Assembly Method Of Thrust Roller Bearing

May 01, 2025

Leave a message

1. Selection and control of the tolerance of the thrust roller bearing chamber: After the thrust roller bearing is pressed into the thrust roller bearing, it should rotate flexibly without any sense of blockage. If there is obvious inflexibility in rotation, it indicates that the size of the shaft is too large and the tolerance should be lowered. If the thrust roller bearing is pressed into the shaft and there is an obvious "rustling" feeling when turning it by hand, it may be that the tolerance of the shaft is too large or the roundness of the shaft is not good. Therefore, when controlling the tolerance of the shaft and the thrust roller bearing chamber, the roundness must also be controlled well. Many domestic manufacturers only control the tolerance, but do not control the roundness.


2. The assembly method of the thrust roller bearing: because the thrust roller bearing is a high-precision product, improper assembly can easily cause damage to the thrust roller bearing channel, resulting in damage to the thrust roller bearing. Thrust roller bearings should have special molds during assembly, and they cannot be knocked at will. When pressing into the shaft, only small rings can bear force, and when pressing large rings, only large rings can be stressed. Pneumatic or hydraulic pressure is required for assembly. The upper and lower molds should be outside the horizontal state during press assembly. If there is any inclination, the channel of the thrust roller bearing will be damaged due to force, and the thrust roller bearing will produce guide noise.


3. Prevention of assembly foreign matter: when the thrust roller bearing is installed on the rotor for dynamic balancing, it is easy to enter the iron filings generated during dynamic balancing into the thrust roller bearing, so it is best to do dynamic balancing before installing the thrust roller bearing . For the convenience of assembly, some manufacturers apply some oil or grease to the thrust roller bearing chamber for lubricating effect during assembly, but it is often difficult for operators to control the amount well. , it is easy to enter the inside of the thrust roller bearing along the shaft when the thrust roller bearing rotates. It is best not to apply oil or grease to the thrust roller bearing chamber. If it must be applied, it must be controlled so that there is no accumulation in the thrust roller bearing chamber.


4. Prevention of paint rust: The characteristic of paint rust is that it often occurs in the sealed motor. The motor sounds very good when it is assembled, but after some time in the warehouse, the abnormal sound of the motor becomes very loud. Remove the thrust roller. Sub-bearings are severely rusted. In the past, many manufacturers would think that it was a problem of thrust roller bearings. After our continuous publicity, the motor factory has realized that it is mainly a problem of insulating paint. This problem is mainly because the acidic substances volatilized from the insulating paint form corrosive substances at a certain temperature and humidity, which corrodes the thrust roller bearing groove and causes the thrust roller bearing to be damaged. This problem can only be caused by the selection of good insulating paint and the assembly after drying and ventilating for a period of time.

Send Inquiry
Contact us if have any question

You can either contact us via phone, email or online form below. Our specialist will contact you back shortly.

Contact now!