1. The fit between the outer ring of the ball bearing and the mounting hole is a transition fit (not an interference fit), and it is recommended to choose ΦxxK7/h6
2. The fit between the inner ring of the ball bearing and the shaft is a transitional fit (not an interference fit), and it is recommended to choose ΦxxH7/k6
3. The specific value needs to be according to the basic size
4. The assembly of the transition fit is to use a wooden hammer for percussion assembly, or static pressure assembly
5. The end of the screw rod must be equipped with a roller bearing, and the smooth rod part of the screw rod is installed in the inner hole of the bearing, so the smooth rod part of the screw rod is processed according to Φxxk6
6. The screw rod is equipped with a bearing, and the bearing must be installed in a fixed place, generally on the bearing seat, then, the hole of the bearing seat is processed in accordance with ΦxxK7
7. Are you worried about whether the bearing will cause damage to the screw rod? No, the end of the general screw rod is made of a smooth rod, which is specially used to install the bearing
8. It is recommended to find a mechanical engineer to help with the design, which is very important
9. Screw the nut on the screw, clamp the nut, or the overhead nut, and let the nut be stressed when knocking on the mounting bearing
10. In fact, the screw is not so fragile, that is, it directly knocks on the shaft end of the screw, as long as it is knocked and does not deviate, the force of the bearing can still be withstanding.
11. For the fit between the bearing bore and the shaft, the fit of the base hole system should be selected, because: in the design, we generally regard the bearing as a standard part, that is to say, the hole of the bearing should be regarded as a benchmark, and the shaft should be changed accordingly, and ΦxxH7/k6 is made of the base hole, ΦxxH7 can be regarded as the bearing hole, and Φxxk6 is the fit of the shaft.
