High-speed bearings have higher accuracy and less surface roughness than vulgar bearings.
The intuitive difference is that the surface of high-speed bearings is smoother than that of low-speed bearings, and the clearance of high-speed bearings is smaller when the outer ring and inner ring are shaken.
What should I do if the high-speed bearing is overloaded and heated?
1. For the case of large size, large load, large vibration, high speed or high working temperature, the bearing and the state should be tightened!
2. Use lubricating oil to reduce friction, large load, and high viscosity oil should be used when the working temperature is high, which is easy to form an oil film, thereby reducing heat generation!
Factors influencing shaft life of high-speed bearings
The length of the on-site installation test life of the bearing is mainly determined by the design and matching of the structural parameters of the bearing itself, as well as the manufacturing quality and process level of the product, but there are some "non-bearing" factors that will lead to the reduction and failure of the bearing field service life. Through the analysis of failed bearings, the main points are as follows:
(1) The selection and installation level of the angular contact ball bearings used in pairs by the spindle maintenance personnel.
(2) The number of times of maintenance and disassembly of the electric spindle. The same set (group) of bearings is disassembled and assembled many times, which must have a certain impact on the service life of the bearing
(3) The newness of the spindle and the difference in the structure and manufacturing quality of the spindle produced by different manufacturers.
(4) The electrical fault of the spindle itself, such as the humid weather in the south, the damp burning of the electric spindle housing, and the silicon steel sheet of the rotor shaft
(5) The lubricating oil for oil spray cooling contains impurities.
(6) The technical quality and sense of responsibility of machine tool operators. For example, due to many operation errors in the test, the oil is cut off, and the grinding head is flooded, which burns the bearing.
(7) Proper storage of bearings, such as serious bearing corrosion, bearing pollution, etc.
We know that the speed of 3000 ordinary bearings can be withheld, more than 5000 speeds can be used to use high-speed bearings to assemble, and the high-speed bearings with smaller clearances are more suitable for this kind of work, and the above is the introduction of high-speed bearings.
